Which two surfaces define flywheel step height?

SouthEast Clutch FW1145 flywheel from the SECLUTCH catalog

Picture a solid flywheel on the workbench, clutch side up. The friction lining runs against a broad circular track. Farther out, the clutch cover rests on machined pads or a mounting ring. The step is the distance along the crankshaft axis between those two planes. If the friction track sits below the cover seats, it is recessed. If it stands above them, it is raised.

What to put on the machine-shop ticket

Suppose a machinist resurfaces only the friction track of a recessed flywheel. The new surface may be perfectly smooth, yet the recess is now deeper. The cover still sits at its original height while the disc sits farther away. That changes the geometry the pressure plate was designed to work with.

A useful inspection record names the flywheel, identifies both measuring surfaces, and gives the measured difference with units and direction. For example, write “friction face below cover seats” beside the reading. Compare it with the specification for that exact assembly and confirm that its manufacturer permits resurfacing before authorizing machining. A catalog photo cannot supply that dimension.

Advanced Clutch Technology · Flywheel Resurfacing
EXEDY · FAQ

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.